Lycris Byrne Tank-in-Tank (Buffer Tank)
It is a straightforward procedure to replace a pre-existing hot & cold domestic water system with a Lycris-Byrne glass-lined steel hot water storage cylinder featuring a fully-automatic, stainless steel, silent pressuring pump.
The system eliminates the need for electric power showers and the system can be expanded at a later stage (another bathroom) without any further changes to the pump or cylinder, as both hot and cold water are permanently pressurised.
The changeover, from a flow to a pressurised flow, can be achieved in less than a day. These cylinders can be used in place of the traditional copper hot water cylinder, using standard B.S.P. connections.
|
V
|
=
|
1/2" ET ventilation
|
|
TS
|
=
|
1/2" IT thermometer sleeve
|
|
HFP
|
=
|
1" ET heat flow pipe
|
|
BFP
|
=
|
1" ET boiler flow pipe
|
|
HRP
|
=
|
1" ET heater return pipe
|
|
BRP
|
=
|
1" ET boiler return pipe
|
|
CW
|
=
|
3/4" ET cold water pipe
|
|
HW
|
=
|
3/4" hot water pipe
|
|
C
|
=
|
3/4" ET circulation
|
- The SISS upright solar storage tank combines a heat buffer storage tank with a service water storage tank.
- Each 550, 750, 900 or 1100-litre heat buffer storage tank with black vanishing has a sealed-in 150, 200 or 250-litre service water tank with DIN 4753-compliant enamelling.
- A large-surface, high-performanace bare-tube heat exchanger (2 to 3.45m2) is sealed directly into the buffer storage tank to ensure the most efficient heat transfer.
- Variable sensor positioning possible by means of 2 sensor tubes.
- A wide variety of heat sources (heat boiler, collector, heat-pump, tiled stoves) can be connected without problems.
- Heat insulation: 100mm soft foam with plastic outer jacket in silver-grey.
- A reconnectable flange immersion heater with 7.5/5/2.5 kW can be mounted in the service water storage tank from above.
- Drained via a cold water pipe.
- Operating temperatures: max. 95°C for service water and heat buffer storage tanks, max 110° for heat exchanger
- The SISS can be connected to a variety of heating devices such as a radiator or floor heating system.
- Acessories: AS active layering system EBH-SISS immersion heater.
The Lycris-Byrne Tank-in-Tank is a hot water cylinder inside a geothermal collector/buffer tank combining the two functions into a single storage unit.
The glass lined stell inner tank has an operating pressure of 6 bar.
The outer buffer tank has an operating pressure of 3 bar and may be connected to the heat sources listed below:-
- Heat Pump
- Gas or Oil Boiler
- Solar Panels
- Pellet Burning Stove
- Wood Chip Stove
- Solid Fuel Stove
An electric immersion heater may be installed into the inner tank which can be fed from electric mains, wind turbine or photovoltaic cell.
A separate 100 mm foam insulation jacket ensures minimum heat loss.
Available Capacities & Dimensions:-
Tank-in-Tank (Buffer Tank)
Email this to a friend